Motor control systems
drylin® D7 stepper motor output stage (NEMA11/17) with cycle/direction
- Can control stepper motors with up to 2.7A continuous current at supply voltage of up to 48V
- Ready to use immediately
- Easy control
- Exact positioning
- Free pattern programs
drylin® D8-(X) stepper motor output stage (NEMA23/24)
- Suitable for 56 - 60mm motor flange size (NEMA23-24)
- Up to 5.5A peak current
- 5-24V control & 24-48V load voltage
- Operation mode 1: clock/direction
- Operation mode 2: D7 & D7-1: jog mode; D7-2& D7-3: loop mode
- Quiet operation & automatic tuning
- Free pattern programs
drylin® D9-(X) stepper motor output stage (NEMA34)
- Can control stepper motors with up to 7 A continuous current at supply voltage up to 48 V
- Ready for immediate use
- Simple control
- Accurate positioning
- Free pattern programs
drylin D6 DC motor output stage
New
drylin D6 DC motor output stage
- Ready for immediate use. No parameterization or programming necessary
- Left/right run via digital input
- Velocities & accelerations via external PWM input signal
- 12-24V supply voltage
- 10A nominal current / 30A peak current
- Free pattern programs
drylin D5 DC motor output stage
New
drylin D5 DC motor output stage
- Ready for immediate use. No parameterization or programming necessary
- Left/right run via digital input
- Velocities & accelerations via external PWM input signal
- 12-24V supply voltage
- 10A nominal current / 30A peak current
- With housing for industrial use
- Free pattern programs
drylin® D3 for direct current motors
- Simple automation directly using the control system without software and/or PC
- Operation with limit switch or via power consumption
- Left/right operation and speed control directly on the housing
- Option for external switches/joysticks
- Various modes of operation, such as tip operation and start to finish (semi-automatic)
- Various adjustable acceleration ramps
- Power supply via 24V/2.5A
- Free pattern programs
drylin® D1 motor control system for stepper, DC and EC/BLDC motors
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
- Free pattern programs
drylin® D2 motor control system for stepper, DC and EC/BLDC motors
- A wide range of automation tasks by simple parameterisation, no programming necessary
- For single axes, line, flat, linear and room linear robots and delta robots
- No software installation or app required
- Use with PC, tablet or smart phone
- Stepper (ST), DC and EC/BLDC motors with up to 21A peak currents and 48V
- Digital inputs/outputs, analogue inputs, CANopen, ModbusTCP (CANopen Gateway) for connection to master control systems such as Siemens or Beckhoff
- Free pattern programs
- Further information on dryve D1 info page
