1 from 2
igus-icon-lupe
igus-three-dimensional-model
- Part number: JSM-0104-02
- Material: iglidur® J
- Shape: Sleeve bearings
- Dimensions:
- d1 1.5 mm
- d2 4 mm
- b1 2 mm
- Adjust dimension
- Manufacturing method: Injection moulding
- Service life:
- Kiváló kopásállóság szobahőmérsékleten
- Nagyon jó kopásállóság közepes hőmérsékleten
- Kiváló súrlódási együtthatók
- Alacsony nedvességfelvétel
- Kiválóan ellenáll a különféle közegeknek
- Jól ellenáll a peremterhelésnek
- Ellenáll a rázkódásnak és az ütéseknek
- Por- és szennyeződésálló
- A DIN EN ISO 846-nak megfelelően penészálló
iglidur® J | The versatile endurance runner
iglidur® J is characterised above all by the lowest coefficients of friction in dry operation and its very low stick-slip tendency. With a maximum recommended surface pressure of 35MPa, iglidur® J is not suitable for extreme loads.
Typical application areas
- Vending machinery
- Printing industry
- Beverage industry
- Aviation
- Cleanroom
When to use it?
- At high speeds
- When highest wear resistance is required at low to medium pressure loads
- When lowest wear is required with a variety of different shafts
- When low coefficients of friction in dry operation is required
- When the material should be vibration-dampening
- When good chemical resistance is required
- Best behaviour with soft shafts
- Low moisture absorption
When not to use it?
- If high pressure loads occur
- If short-term temperatures greater than +120°C occur
- If a cost-effective material is required for occasional movements
Unsure if it fits?
